New kits Old kits More kits!

Sabtu, 16 April 2016

New and Updated Kits

Calendar Islands Yawl under construction
Updated Deer Isle Koster (KDI) kits being cut out West


The CIY hull#1 is being expertly built in Duluth and everything is looks really good. The boat has been set up and planking has started.

The building jig set up was all CNC cut and self-jigging. In a post on the Wooden Boat Forum about the CIY project, the builder says "I have the distinct sense of the boat building itself" as he assembled the building jig and is not planking within 10 days time working on the side.

Here is the boat so far, all photos courtesy of Jim Levang, builder and owner of hull #1.

The building jig set up. All parts are CNC cut.

The stem, bulkheads, centerboard trunk, and transom all set up. They were all CNC cut.

Bottom and garboards attached!

But thats not all! You can also get the updated KDI. This model is not my own design, but drawn originally by Bruce Elfstrom, friend, fellow designer, and small boat guru from Connecticut who plays with boats, particularly Scandinavian type boats on the side. I have done a lot of new design work with the help of three builders of hull #3, 4, and 5. Photos below courtesy of Frank Stauss in New Jersey. He looks to be doing a fabulous job. 
New Jersey KDI.

NJ KDI.

The Deblois Street Dory is getting a few tweaks to the building jig set up to facilitate building and then two kits will be cut. Finally, the last project will be to finish the Drake 19, a new model. A bit of a line up is forming there for this kit. Everything is on track to be done by the end of May. Then I am going rowing and sailing, dang it!



Related Posts by Categories

0 komentar:

Posting Komentar